Please mention anything important I could have missed. I had already entered mkdir /jffs/opt and mount -o bind /jffs/opt /opt but after that, in case it matters, ls /jffs/ showed me nothing, and /opt does not show up anywhere after entering df. Sed -i s/192.168.*/192.168.1.1/ /tmp/nfĪnd try again - or wait to see if your download continues anyway.įor running Optware on JFFS (not recommended), Enter They should help you get it up and running. You might want to go to DD-WRT site and look at some of the stickies there. v24-sp1 had lots of problems with DHCP and its no longer recomended. Warning: local nameserver is different than gateway! Make sure your using the latest recommended version of DD-WRT, v24-sp2. When I download and run optware-install-ddwrt.sh it gives me the following log: Checking system config. I did the following through telnet: nvram set jffs_mounted=1 Installed the latest DD-WRT (Firmware: DD-WRT v24-sp2 (11/21/10) std build 15778), and tried following the post here to setup a Client Bridge, and a Virtual. WARNING: Do not use the K2.6 builds unless you are certain your device can support it It will brick. I'm facing problems trying to install optware packages on a TP-Link TL-WR841n v8 running DD-WRT v24-sp2 (4MB flash, 32MB RAM). DeviWiki:DD-WRT/v24 pre sp2 K2.6 Features.
0 kommentar(er)
